Special Instructions
This test will be run against the Gazelle Patient Registry tool acting as a PIXm Patient Identifier Cross-Reference for mobile Manager. PIXm connector's endpoint is available through this url : https://ehealthsuisse.ihe-europe.net/pixm-connector/fhir/Patient/$ihe-pix?
In addition, the messages your system under test exchanged with the
tool will be captured by Proxy and validated against EVS Client.
Description
The purpose of this test is to check that your CH:PIXm Consumer can
send 2 correct PIXm query messages and correctly handles the results.
1st query
sourceIdentifier : Patient's local assigning authority is said to be DDS with OID 1.3.6.1.4.1.12559.11.1.4.1.2 and his MPI-PID is DDS-72618.
targetSystem : You have to retrieve this Patient's EPR-SPID, known with this assigning authority : 2.16.756.5.30.1.127.3.10.3 (targetSystem).
2nd query
sourceIdentifier : Patient's local assigning authority is said to be CHPAM with OID 1.3.6.1.4.1.12559.11.20.1 and his MPI-PID is CHPAM97.
targetSystem : You have to retrieve 2 identifiers :
- this Patient's EPR-SPID, known with this assigning authority : 2.16.756.5.30.1.127.3.10.3.
- this Patient's antother local ID, known with this assigning authority : 1.3.6.1.4.1.12559.11.25.1.19.
You need first to configure your system to connect to Patient Registry. The endpoint of the PIXm Manager actor is https://ehealthsuisse.ihe-europe.net/pixm-connector/fhir_ch/Patient/$ihe-pix.
Please note that ,if Proxy is available, you'll find the corresponding port for this simulator in Gazelle Test Management through this link : https://ehealthsuisse.ihe-europe.net/gazelle/configuration/configurations.seam
Execute the test step as described in the next section.
For
each step, you are requested to provide the permanent link to the
message exchanged with the simulator, either in Proxy or in EVS Client (copy/paste/test your url if proxy is not available).
If you use directly EVS Client :
- If you're using a GET request: select menu EPR > HTTP Validation >Validate and choose the corresponding validation profile
- If you're using a POST request: select menu EPR > CH EPR FHIR >Validate and choose the corresponding validation profile
- Click on Validate.
- If
you have the ability to do so in your system, upload a screenshot of
the result received by your system, demonstrating that your system
correctly integrates the response from the simulator.
Evaluation
The monitor will check that:
- All the messages produced by
your system under test successfully pass the validation against the
tool. Validation status shall be "PASSED".
- The received informations are integrated and displayed by the system under test.